Mounting Options
Brackets may be welded onto any 33 Range Motor, to give a shaft centre height of 48mm. They are available in 2 types. If those with an 18mm distance (’D’ in the diagram) are welded to a 33 Range Motor, then its part number is extended with ‘BKT18’. Alternatively those brackets with 26mm between the studs may be ordered with a motor by adding ‘BKT26’ to its part number.
 |
 |
| In addition, Remco have a 2 point mounting bracket where both mounting studs are in line axially with the shaft. Fitting this bracket to a motor will add ‘BK18’ to the part number. |
|
|
B. Foot Mount
A foot mounting may be welded or screwed to the rear endshield.
|
C. Resilient Band Mount
Motor Bodies may be wrapped in a rubber sleeve to reduce vibration when radial clamps are used.
|
|
D. Vibro-Arms
A variety of Vibro-arms incorporating resilient blocks may be supplied for attachment to endshield mounting positions.
|
E. Body Band Mount
For use with blower mounting kits.
|
|
F. Lug Mounts
Lugs, either drilled or slotted and with optional anti-vibration grommets may be fitted in any position required on the motor body.
|
G. G180 Mounting
The G180 Bracket provides a firm endshield mount and incorporates resilient blocks to reduce transmitted vibration. |
|
H. Endshield Tapped Holes
Motor endshields may be drilled and tapped in a number of positions, either end.
|
I. Endshield Studs
Once drilled and tapped, endshields may be fitted with threaded studs if required. |
|
J. Flanged Endshield Mount
The Flange may be drilled or slotted and fixed to the motor body using through bolt extensions.
|
K. Triangular Plate Endshield Mount
The Triangular Plate is available in 4 different mounting pitch circle diameters. 92mm, 95mm, 111mm and 145mm
|
|
